Diagram of connection for using voltage stabilizer/line conditioner

 
Connection for using voltage stabilizer/line
conditioner with Single Phase electrical system,
Type 1 by put plug-in at the receptacle

Feature of installation and connection for using stabilizer
with Single Phase, Type 1. This is the way of connection
for using stabilizer that it has low power rating with power supply system and connector equipment, which power consumption rating not too high by taking a plug of stabilizer to plug with the receptacle at the wall, which it must be 3 pins type and set line of electrical system correctly match to position of Line, Neutral and Ground by regulation point of receptacle and take a plug of stabilizer or electronic equipment to plug at receptacle of stabilizer, even through
a plug that connect for using is 3 pins or 2 pins type, then it can connect for using through stabilizer.

 
Connection for using voltage stabilizer/line
conditioner with Single Phase electrical system,    
Type 2 by connect power line into the Terminal pole

Feature of installation and connection for using stabilizer
with Single Phase, Type 2. This is the way of connection for using stabilizer that it has high power rating with power supply system and connector equipment that it has high power consumption rating by set power line from MDB into stabilizer at Input point of Terminal, then set power line to Output point through connector pole of instrument, machine and other equipment or set power line to MDB first, then connect to connector equipment by need to repeat grip completely and match line pole with electrical system correctly of Line, Neutral and Ground position.

   
Connection for using voltage stabilizer/line        conditioner with Three Phase electrical system
 

Feature of installation and connection for using stabilizer
with Three Phase, Four Wire. This is the way of connection
for using 3 Phase, 4 Wire electrical system with power supply system and connector equipment by set power line from MDB into stabilizer at Input point of Terminal, then set power line to Output point through connector pole of instrument, machine and other equipment or set power line to MDB first, then connect to connector equipment by need to repeat grip completely and match line pole with electrical system correctly of Line R, S, T, Neutral and Ground position.


Silicon Power Supply Co., Ltd. 455/13-16 Soi Phibunuppatham, Latphrao Road, Samsennok, Huaykwang, Bangkok 10320
Tel: +66 2275 1182, +66 2275 1275, +66 2275 7161, +66 2276 9973 Fax: +66 2275 7309
 E-mail : info@siliconthai.com
Copyright 1997-2011 Silicon Power Supply All right reserved